Custom Built in the USA.

The Model # NCC-1701-REFIT-A Wide Range Adjustable Flasher board was designed for many of the Star Trek class of Plastic models, including the Polar Lights 1/350 versions of NCC-1701 "Refit" , "A" and NX-01. The wide range of adjustment allows this board to be used with many Federation starships as well as other types of models or projects.

Board contains both circuits for Navigational Running lights as well as for the Navigational Strobe lights..

Built using high quality components for longevity, and Small enough to fit inside the model itself or its stand.

Measures Approximately 2" x 1 15/16"

Powered by 9volt(Recommended) or 12 volt power supply either by battery or by a"Regulated" DC power supply adapter that you plug in to the wall(Not Included). (NOTE: 12 volts may run warmer. 1/2watt resistors may be required instead of 1/4watt resistors for each led.)  

Board Features:

Each Circuit may be used to strobe 10 single leds in parallel or 10 pair of leds in parallel wiring 2 leds in series for a total of 20 leds per circuit, depending on your power supply.(note: Enterprise NCC-1701 "REFIT" "A" Model requires only 4 Nav strobes and 10 Nav running Lights)

Easy connection via a Screw connector terminal block.

Adjustable trimpots for wide range of flash rate adjustment on both circuits.

Nav Strobe Approximate flash rates: .3 to 1.7secs.

Nav Running Approximate flash rates: .63 to 2.20 secs.

Video

Please view video below to see the Boards Min and Max speed flash rates. LEDs in video are for example only.

Package Contents:

1 x Flasher Board fully assembled
10x 3mm white LEDs.
2x 3mm green LEDs.
2x 3mm red LEDs. 14x resistors.

PDF Download Detailed 6 page Instruction Manual including information about LED's(Example setup for Parallel and Series), resistors, DC adapters, and voltage regulators.
PDF manual

If the Item is out, you may email a request TO:
      sales@starling-tech.com